Hard Head 018984 Bedienungsanleitung Seite 15

USE
Apply access code
1. Plug in the plug. H flashes in the display and the
light goes on. The unit is in standby mode (figure 1).
2. Press the LEARN button on the opener for at
least 2 seconds. • is shown on the display
(figure 2). Press the button on the remote
control to control the garage door twice. •
flashes several times, after which H is shown
(figure 3).
3. The code has been learned by the opener.
FIG. 1
NOTE:
Repeat the above steps if codes for additional
remote controls are to be learned. The opener can
learn codes for up to 10 remote controls.
Erase all remote control codes
Press and hold the LEARN button on the opener. •
is shown on the display and switches to H. When H
EN
15