Adding The Control Point To A Roller Garage Door Motorisation - simu DIGICODE HZ 2C Installationsanleitung

Adding the control point to a roller garage
door motorisation
SD 100 Hz
1
PROG
24
Memorising the control point for complete opening operation
1. Press the PROG button on the receiver until the indicator light is lit continuously (approx. 2 s).
2. Enter your master code.
3. Press the button on the control point which will open the garage door completely.
ð The motorisation PROG indicator light flashes.
2s
2 3
©
Copyright
2022 SIMU SAS. All rights reserved.
DIGICODE HZ 2C