Heimplanet FISTRAL Beschreibung Seite 4

F I R ST
AS SEMB LY
FIRST ASSEMBLY PROCEDURE:
01 SPREAD THE IDG (INFLATABLE DIAMOND GRID)
Spread out the IDG (Inflatable Diamond Grid air frame), evenly on the ground. Make sure
the individual struts are not twisted when doing this. Now use the pump to slowly inflate
the frame until it stands upright. To do this, simply connect the pump to one of the two
valves using the adapter. The pump adapter can be found in a small bag together with
the air frame.
CONNECT THE INNER TENT TO THE GRID
To do this, spread out the inner tent and position the inner tent entrance. Then connect
the toggles on the inner tent bottom to the lower D-Rings on the frame struts. Simply
push through and twist. That's it.
03 INSTALL THE OUTER TENT
Now spread out the outer tent and hang it suspended from inside the air frame. To do
this, secure the toggles to the D-rings.
04 CONNECT THE INNER TENT ROOF WITH THE OUTER TENT
Finally, attach the inner tent to the inside of the outer tent using the small toggles.
Connect the toggles to the provided O-rings on the interior of the outer tent. The inner
tent also can be used on its own (without the outer tent). To do this, attach it directly
to the air frame.
05 PUMP UP THE FRAME
You can now pump up the IDG until the struts are fully inflated with air. Everything else
happens by itself.
The first time you assemble Fistral, you must
connect the frame, the inner and the outer
tent with each other. You only need to do this
once. Once these are connected, you can pack
everything into the tent bag "as is". The next time
you use your Fistral, simply unpack it and pump
it up. The tent - including the outer and inner tent
- pitches itself.