Mounting The Clamping Ring On A Other Manufacturers' Turntables - clearaudio electronic Satisfy Kardan Aluminium black Bedienungsanleitung

User manual / Bedienungsanleitung

2.2 Mounting the clamping ring on a other manufacturers' turntables

Drill three holes into the turntable chassis to mount the aluminium clamping ring.
Use the measurements given in the drawing template below to ensure the correct position of the
three holes (Pic. 3).
Use a 3.3mm drill for this step. After you have drilled the three holes, thread the holes using an
appropriate tap cutter. If the material of the turntable chassis is not suitable for threading, please
use a 4.5mm drill for the holes. In this case, you will need longer screws with nuts to fit the tonearm
base.
Please note that this image is not true to scale.
Pic. 3: Drilling template for mounting the tonearm base on a other manufacturers' turntable
Page / Seite 8 © clearaudio electronic GmbH, 2022-11