Technical Data - ZANKER KITN323K Benutzerinformation

Problem
The control panel becomes
hot to the touch.
There is no sound when you
touch the panel sensor fields.
comes on.
comes on.
and a number come on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes

9. TECHNICAL DATA

9.1 Cooking zones specification
Cooking zone
Middle front
Middle rear
The power of the cooking zones can be
different in some small range from the data in
16 ENGLISH
Possible cause
The cookware is too large or you
put it too close to the control pan‐
el.
The sounds are deactivated.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the
zone.
There is an error in the hob.
Nominal power PowerBoost [W]
(maximum heat
setting) [W]
2300 3700
1400 2500
Remedy
Put large cookware on the rear
zones, if possible.
Activate the sounds. Refer to "Daily
use".
Refer to "Daily use".
Put cookware on the zone.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
comes on again, disconnect the hob
from the electrical supply. After 30
seconds, connect the hob again. If
the problem continues, speak to an
Authorised Service Centre.
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PowerBoost
maximum du‐
ration [min]
10
4
the table. It changes with the material and
dimensions of the cookware.
Cookware di‐
ameter [mm]
180 - 210
125 - 145