kiin STIRIO Benutzerhandbuch Seite 4

English
2. Using the Stirio
1. Insert the axle into the stirring blade from
the bottom and pull it until it sits
securely. You will need to fully charge the
motor unit before using it the fi rst time (see
point 4 for how to do this)
2. Insert the axle and stirrer blade into the pot. You can do this
either before or after adding food. If you insert the blades
after adding food twist the stirring blade into the pot as far
as possible until it reaches the bottom. The blades will "dig
into the food" once the motor unit is attached and starts tur-
ning. Make sure that the blade wings touch the side of the
pot. The stiring action will ensure the wings stay in contact
with the pot walls.
Diameter
min: 150 mm
3. Attach the bridge while ensuring that the axle comes
through the center hole. Use your thumb and remaining
fi ngers to squeeze open the clamp on both sides to place
the bridge over the edge of the pot. Make sure you press the
bridge thoroughly down so the bridge touches the edge of
the pot.
4
Stirio_manual_09-13_01.indd 4 Stirio_manual_09-13_01.indd 4
Diameter
max: 250 mm
Height Height
min: 75 mm max: 177 mm
12.09.14 10:06 12.09.14 10:06