Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Removing Flooring
1.
Fully tilt the attachment rearward and lower the
loader arms. Use this as the starting angle for
scraping the floor.
Note:
Using a scraper angle greater than 30
degrees can cause premature wear on the blade
and reduce visibility of the area being scraped.
2.
Drive the traction unit forward to remove flooring.
3.
As the blade edge wears, tilt the scraper
attachment in small increments as needed.
Note:
If the blade edge becomes dull,
manually rotate the blade-holder assembly 180
degrees to use a new edge. Use the starting
angle described in step
blade-holder assembly.
Figure 7
1
after rotating the
Figure 8
Transport Position
When transporting the attachment, keep it as close
to the ground as possible, no more than 15 cm (6
inches) above the ground. Tilt it rearward.
g371242
1. No more than 15 cm (6
inches) above the ground
g371267
10
Figure 9
2. Tilt the attachment
rearward.
g371206
Werbung
Inhaltsverzeichnis
