Important Warnings; Before The First Use; Filling With Water - Zelmer ZGS1600 Benutzerhandbuch

EN
to 2000m above sea level.
The fabric steamer must not be left unattended while it is
connected to the supply mains.
The fabric steamer is not to be used if it has been
dropped, if there are visible signs of damage or if it is
leaking.
Keep the fabric steamer and its cord out of reach of
children less than 8 years of age when it is energized or
cooling down.
CAUTION: Hot surfaces. Surfaces are liable to get
hot during use.

IMPORTANT WARNINGS

This appliance is designed for home use and should never be used for commercial or industrial use under
any circumstances. Any incorrect use or improper handling of the product shall render the warranty null
and void.
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the
product label. Do not use, connect or disconnect the device to the mains with your hands or feet wet. Do
not use any accessories other than those supplied.
The mains connection cable must not be tangled or wrapped around the product during use. Do not pull
on the connection cord in order to unplug it or use it as a handle.
Do not direct steam at people and animals.
Do not place the appliance under the tap to fill the water tank, or immerse it in water or other liquids. Unplug
the product immediately from the mains in the event of any breakdown or damage and contact an official
technical support service. In order to prevent any risk of danger, do not open the device. Only qualified
technical personnel from the brand´s official technical support service may carry out repairs or procedures
on the device. Only an official technical support service centre may carry out repairs on this product.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for the
non-observance of these warnings.

BEFORE THE FIRST USE

In the first use they can break off odors or fumes that sent quickly. Do not spray for the first time on clothes
and there may be traces of dirt on the steam head.

FILLING WITH WATER

Remove the mains plug from the wall socket before filling or emptying the garment. (Fig.1) To remove the
water tank (E), turn it from locked position to unlocked position and pull it firmly away from the garment
steamer main body. (Fig.3) Open the silicon cap (F) and fill in up to the max. (Fig. 4). Make sure that the
silicone cap is correctly closed. Once full, refit the water tank (Fig. 5). Refill the water tank as and when
8