Basic Operation; Dab Operation - auna MC40 DAB Bedienungsanleitung

EN
Antennas
Find a location and an orientation that provide good reception, and then
set up the antenna.Keep the antenna away from the speaker cords and the
DC power cord to avoid picking up noise.Before unplugging the FM/DAB
antenna, make sure the system is turned off to preserve your own FM and
DAB settings.

BASIC OPERATION

Insert the jack of the supplied mains adapter into the socket on the rear
of the radio and the power plug of the adapter into the wall socket. The
display will show "SCANTIME". The unit is now updating the time from the
broadcaster. Wait for a while until it is finished and the real time will be
display.
Press the STANDBY button to turn on the unit. To turn off, press the
STANDBY button again.
DAB/FM/CD/USB/BT/TAPE
Press the SOURCE button to select from different sources.
Volume Control
Turn the VOLUME control or press the VOL-/VOL+ buttons on the remote
control to change the volume.
Adjusting the Antenna
The wire antenna at the rear panel of the unit should be extended and
altered to ensure a good DAB/FM reception.

DAB OPERATION

The first time the DAB mode is selected, it will automatically scan for
available DAB stations. Wait until the scanning has finished. The display will
show the scanning progress. After scanning it will tune to the first station.
Stations are listed in numerical then alphabetic order. All stations scanned
are stored. The next time the unit is turned on there will be no automatic
scanning.
Auto Scan
1. Turn on the unit and select DAB mode
2. Press the SCAN button on the front or remote control, to start auto-
scanning for available DAB radio stations.
38