INKBIRD IHT-1S Bedienungsanleitung Seite 4

Instruction
● Button Instruction
Short press and release button can hold
the measured temperature or cancel the hold
temperature when unit runs.
● How to Enter the Setting Mode
Press and hold the button for 8 seconds
to enter setting mode, will appear "CF" on the
screen. Short press one time to choose "C" or
"F" .Press and hold for about 2 seconds to
enter into the calibration mode. LCD screen
shows CA letter. Short press once, it will
show the calibration value and blink, then you
can short press the button to adjust the
desired calibration temperature or hold the
button to set fast. The calibration tempera-
ture will be automatically saved after 10
second if there is no operation.
Notes: The calibration will be reset to 0.0
℉/℃ if you change the temperature unit
between ℉ and ℃, the calibration need to be
reset.
● LCD Screen (Liquid Crystal Display)
Display the measured temperature, HOLD
letter, charging mark and battery capacity
levels.
2