Parts And Components; Before Use - cecotec Bamba IONICARE 6000 ROCKSTAR SOFT PRO Bedienungsanleitung

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Round concentrator
2. Air outlet
3. Wire rack
4. Air inlet
5. Handle
6. Power switch
7. Mode button
8. Levels selector
9. Power cord
10. Flat concentrator
11. Professional concentrator
12. Diffuser

2. BEFORE USE

Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If any sign of visible
damage is observed, contact immediately with our official Technical Support Service.
3. OPERATION
- Wash and condition your hair.
- Dry it with a towel and comb it.
- Make sure that the mains voltage matches the voltage stated on the rating label of the
appliance and that the outlet is grounded. Plug the device to a socket.
- A slight odour and smoke might appear when heating the device for the first time. This is
perfectly normal and indicates that the system is functioning correctly.
- Additional and removable concentrator included.
Note:
Make sure the device is turned off when you assemble the concentrator or diffuser. Do not
assemble or disassemble these attachments while the device is operating to avoid scalds.
- Keep your hair 10 cm away from the air inlet while the device is operating to avoid your hair
from getting stuck inside the device.
- To avoid burning the hair, keep it more than 3 cm from the air outlet.
26 IONICARE 6000 ROCKSTAR SOFT PRO
Fig. 2
- Press the mode button to select the alternate temperature cycle, the light indicator will
switch from blue to orange alternately.
- The hairdryer saves the last mode with which the device was operated; therefore, if the
cool air mode was used before turning the device off, it will start operating with cool air
once turned on.
- Press the mode button to switch from cool air to hot air. The hot air mode has 3 power
levels. To switch mode, simply press the mode button and the pattern followed by the
device will always be the same. For example, if the hairdryer is turned on in heat level 3
and you want to change mode:
1. Press the mode button once to select cool air mode.
2. Press the level selector once to select level 1.
3. Press the level selector a second time to select level 2.
4. Press the level selector a third time to select level 3.
- In case your hair is still wet, you can select maximum power.
- We recommend a lower power in case the hair is dry or damaged.
- Dry your hair evenly to avoid damaging it.
- Unplug the device when it is not longer going to be used.
- Allow it to completely cool down before cleaning or storing it.
Concentrators:
The concentrator or flat nozzle attachment allows air to be blown out with more power,
concentrated and accurately. These accessories can be used for straighter and much more
perfect results, as it allows using it easy and accurately.
- Round concentrator: For natural, straight hair.
- Flat concentrator: For perfectly straightened hair.
- Professional concentrator: For professional finish.
Diffuser
- The hair diffuser is designed to dry straight or curly hair.
- This attachment can be used to increase hair volume or to enhance curls.
- Keep the hairdryer in a vertical position when being used.
- If you wish to add volume to the roots, place the diffuser teeth between hair, and once in
contact with the scalp, move the hair dryer in circles to distribute heat.
Warning
If the product suffers overheating, it will automatically turn off. In this case, unplug it from
the power supply and allow it to cool down for a few minutes. Follow the instructions on the
Cleaning and Maintenance section and turn it on again. Please contact our Technical Support
Service in case the problem is not solved.
ENGLISH
IONICARE 6000 ROCKSTAR SOFT PRO 27