Klimatronic Heat Safe 1500 Bedienungsanleitung Seite 10

Part description (2)
1. Power setting switch
2. Thermostat control
3. Handle
4. Oil filled fins
5. Hour timer switch (only HEAT SAFE 1510, 1550, 2010 and 2050)
6. Turbo (only HEAT SAFE 1520, 1550, 2020, 2500 and 2050)
7. Turbo switch (only HEAT SAFE 1520, 1550, 2020, 2500 and 2050)
8. Castors
9. Cord storage
Operating your KLIMATRONIC HEAT SAFE Oil-Radiator
Place the heater on the floor at least 90 cm away from the wall and any other objects such as furniture,
curtains or plants. (Make sure the power supply use corresponds to the one on the rating label) With the
thermostat control switch and the power setting switches in the "OFF" position; Plug the heater into the
main power supply.
Using the Thermostat and power switches
1. Room temperature can be adjusted using the thermostat. Simply turn the thermostat knob clockwise,
to increase the heat, and anti-clockwise to decrease the temperature, until you reach the desired
temperature.
.
2 The heating to one of the following power settings change.
a) Switch one (I) for press
600W (1500 series)
800W (2000 series)
1000W (2500 series)
b) Switch two (II) press for
900W (1500 series)
1200W (2000 series)
1500W (2500 series)
3. Switch one (I) and two (II) simultaneously for
1500W (1500 series)
2000W (2000 series)
2500W (2500 series)
4. When the power is switched on, the lamp wil light up.Note: SAFE HEAT climate is filled with oil
and slowly cools down after switching off the electrical supply. Let the appliance cool down before
moving; for easy transport should use the standard grip.
Models with a 24h timer (only for KLIMATRONIC HEAT SAFE 1510, 1550, 2010 and 2050):
To program heating, proceed as follows:
1. Look at the time on your clock or watch. Assuming it is 10.00 o'clock, turn the
numbered timer disk clockwise until the number 10 on the disk coincides with the
pointer Δ on the timer. Set the periods of time when you want the appliance to
work by pushing the teeth inwards. Each tooth corresponds to a period of 15
minutes. This will leave visible sectors which correspond to the periods of
operation. When set, the radiator will operate automatically each day during the
times programmed (important: the radiator must always be plugged into the
socket.)
2. To change the programming, push all teeth back into the initial position and set
the new periods of functioning.
3. If you want to make the appliance operate without programming, push all the
teeth into the centre. In this case, to turn the mains to avoid continued operation
of the timer.
4. Models with mechanical 24h timer (programming of delayed start). With this
timer, you can set the hour you want the radiator to start operating
automatically. Proceed as follows.
5. Turn the appliance on and select the required power and temperature by
proceeding as follows.
6. Rotate the timer knob clockwise until the pointer coincides with the number
corresponding to the required hours. The appliance will begin to warm up after
the set time has expired.
INSTANT HEAT (+ 400W) (only for KLIMATRONIC HEAT SAFE 1520, 1550,
2020, 2500 and 2050)
This model is fitted with a heating fan which heats the room more quickly. To turn this function on, push
the button into the position
1. Turning the thermostat control clockwise will increase the set temperature
2. Turning the thermostat control anti-clockwise will decrease the set temperature
.