Firmware Update - Autel Smart Controller Se Schnellstartanleitung

12. Firmware Update

To ensure users have a premium operating experience, Autel
Robotics will update firmware when necessary. You can refer to the
following steps to upgrade.
1. Power on the controller and make sure it is connected to the
internet.
2. Run Autel Explorer App. A pop-up will appear when new firmware
is available. Tap the notification to enter the update interface.
3. Update will start automatically after downloading the latest
firmware. Please restart the controller when the update is complete.
Note
Before updating, please make sure the controller battery is
above 50%.
If the network is disconnected during the firmware downloading,
the upgrade will fail.
The update takes approximately 15 minutes. Make. Please wait
patiently.
13. Specifications
Image Transmission
*Operating Frequency
Max Signal Transmission
Distance(No interference,
No obstacles)
902-928MHz（FCC）
2.400-2.4835GHz
5.725-5.850GHz（Non-Japan）
5.650-5.755GHz（Japan Only）
FCC：15km CE：8km
11