DeLOCK 90600 Bedienungsanleitung Seite 3

English
Safety instructions
• Protect the product against moisture
• Protect the product against direct sunlight
• Do not look directly into the LED diode of the scanner
Beep tones
Melodical beeps Scanner is active
One short beep Scanner reads successful codes
Reset to factory settings
To reset the unit to factory settings, please scan the code below. The device will
then be set as a USB keyboard.
USB Connection
With the code below you can set the scanner as a USB keyboard.
If the system asks for a serial port (USB Com) please scan the following code and
install the driver manually.
RS232 Connection
To establish an RS232 connection with the scanner, please scan the code below.
Baude Rate
4800 9600
Sound settings
The scanner can be set to two different tone settings.
On
Reverse Code reading
To reverse the code settings from white underground to black please scan below
code "enable". To reset please scan "disable".
Enable
115200
Off
Disable
Invoice Mode Setting
Turn on
Picture Mirror Image setting
With the below code you can mirror the codes.
Turn on
Compensation Light
You can choose between 3 options-
Always on Always Off
End character setting
No end character
Add carriage return
Add TAB
Add carriage return + Line Feed
German language setting
Before the first use, please scan the codes below - step by step, to confirm the
German keyboard.
1.
2.
Change Code System - Output German Language
The following codes can be used to switch between UTF-8 and GBK protocol.
GBK - QR Code, Code128, EAN, PDF
UTF-8 - Mobile QR
Turn off
Turn off
On while scanning