Replacing The Lamp - Electrolux RJN2301AOW Benutzerinformation

All manuals and user guides at all-guides.com
Problem
Water flows inside the re‐
frigerator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
Possible cause
The door is not closed
correctly.
The water drainage plug
is not correctly posi‐
tioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.

7.2 Replacing the lamp

Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).
ENGLISH
Solution
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet‐
ter.
Refer to "Operation" chapter.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance.
11