digimess BP3002 Gebrauchsanweisung Seite 6

3.0 Operating instructions
3.1 Mains input
The mains input connector is located on the rear of the unit. Before connecting to the mains supply the user
should verfy that the unit is set to the correct voltage for the country of use
3.2 Mains input fuse
The mains fuse is located on the rear of the unit.
220Vac : T2A 250V
3.3 Power on/off
The mains power to the unit is switched on and off using the POWER on/off pushbutton.
3.4 Voltage and current display
The BP3002 can display the voltage or current readings for both outputs, selected by using the front panel
switch.
3.5 Output voltage and output current
The voltage level for each output is adjusted to the desired value using the Voltage controls. The current
level for each output is adjusted to the desired value usng the Current controls. If the output current exceeds
the set current value the power supply will limit the output current to the set value.
6