Information For Use - Konig & Meyer 12167 Nutzungsinformation

12166 Tray for DJ Desk

Information for use

Intended use
This tray is an add-on for the DJ desk Performance 12165. The tray can be used to create a se-
cond level to hold gear and equipment. The height and inclination of the tray are adjustable. The
tray plate can also be attached to the bracket in two different positions and adjusted infinitely in
alignment and distance. The tray is attached to one leg of the DJ desk.
Foreseeable misapplication
Always remove all equipment before adjusting the height and/or incline. Detach tray from desk
and remove all equipment before transporting. Angling the tray plate toward the back is not allo-
wed during use.
General
The tray must be securely screwed in place on the DJ desk.
The DJ desk must be placed on an even surface that can hold the weight involved. Please
note the use information for the DJ desk.
Please note the maximum weight capacity of the add-on and the DJ desk.
The tray is an add-on, so the desktop should always be loaded first and the tray afterward.
Unload and dismantle in the opposite order.
If the load is out of balance, a secure footing cannot be ensured and there is an elevated risk
of tipping.
Increasing the distance between the DJ desk and the tray significantly decreases stability
Always remove all equipment before adjusting the tray.
To keep equipment from falling, stay within the permissible incline range. If the tray is too flat
or inclined toward the back, the equipment placed on it may slide off the tray plate.
Please note the use information for the DJ desk.
Personal injury or property damage may occur if the tray falls over or down.
The adjustment option means there is a pinch hazard between the components.
The user must be physically fit and technically competent.
The usage information is an integral part of the product and should be kept for its service life
or passed on to any subsequent owner or user.
Warranty
No warranty is given for damage caused by:
Non-observance of the usage information and the "General safety and assembly instructions".
Improper use or use for other than the intended purpose.
Improper installation or use by the buyer or third parties.
Natural wear and tear.
Careless handling.
Improper modifications or repair work by the buyer and third parties.
Impact on components of foreign origin.
Use of non-original spare parts.
Modifications, additions and conversions that may impair safety are prohibited without the manu-
facturer's approval.