Adjusting The Angle; Storage, Cleaning - F2 WB-6275 Gebrauchsanweisung

Adjusting the bindings
The bindings (2) are pre-assembled on the wake-
board (1). You can adjust the position of the
bindings and their angle on the wakeboard (1).
Adjusting the position
To adjust the bindings (2) on the wakeboard (1),
proceed as follows:
1. Use a suitable screwdriver (not included in the
package contents) to loosen the screws (3) on
the bindings (2) (Fig. C).
2. Remove the screws (3), washers (4) and the
sliders (5) from the wakeboard (Fig. C).
3. Place the bindings the desired distance apart
on the wakeboard. Ensure that the wake-
board's mounting holes are visible through the
rails (2a) (Fig. D).
4. Fix the bindings in the preferred position by
placing the sliders (5) in the rails (2a) and
screwing the screws (3) with the washers (4)
into the mounting holes on the wakeboard (1).

Adjusting the angle

You can adjust the angle of the bindings (2) on
the wakeboard (1). To do this, follow the steps
below:
1. Loosen the screws (3) on the bindings (2) with
a suitable screwdriver (not included in the
package contents) (Fig. C).
2. Slide the bindings on the wakeboard (1) to
the preferred angle. This moves the sliders (5)
on the bindings (2a) in the rails (2a) (Fig. E).
3. Tighten the screws (3) on the wakeboard (1)
again.
Use
Retighten the screws (3) on the bindings
(2) before each use of the product.
To do this, follow the steps below if launching
from a jetty or similar:
1. Open the hook and loop fasteners (2b) of the
bindings (2) and loosen them (Fig. F).
2. Using the loops (2c) step into the bindings (2)
with dry feet.
3. Pull on the hook and loop fasteners (2b) and
close them. Start with the lowest hook and
loop fastener.
8 GB
Note: make sure that the hook and loop fasten-
ers are tightly closed.
4. Place yourself with the wakeboard on the
edge of a jetty and hold the pull cord handle
with both hands (not included in the package
contents).
Proceed as follows, if you are launching in the
water:
1. Lie on your back in the water such that you
can reach your feet.
2. Open the hook and loop fasteners (2b) of the
bindings (2) and loosen them (Fig. F).
3. Use the loops (2c) to step into the bindings
(2).
4. Pull on the hook and loop fasteners (2b) and
close them. Start with the lowest hook and
loop fastener.
Note: make sure that the hook and loop fasten-
ers are tightly closed.
5. Grab the handle of the pull cord (not included
in the package contents) with both hands.
Warning: to prevent skin irritation,
wear a neoprene suit when using the
product.
Removing the bindings
1. Let go of the pull cord handle and float on
your back in the water.
2. Bend your legs and open the hook and loop
fasteners (2b) on the bindings (2).
3. Step out of the bindings and swim with the
product to the shore or boat.

Storage, cleaning

Always store the product clean and dry at room
temperature on its front.
We recommend that you transport and store the
product in an appropriate bag.
After each use, clean the product with water
only, and do not use harsh cleaning agents.
Do not leave it in direct sunlight.
Do not store the product in the boot of a vehicle
for extended periods of time when temperatures
are high (60˚C/140˚F).
When storing for the winter, do not place any
sharp-edged objects on the product.