Maintenance Instructions - Desoutter CVI2 Bedienungsanleitung

English
Important !
Always make sure to attach CVI2 tool
adaptor support to a fixe robust point such
as a post, best if verticaly.
To have firmware updated, contact your
Desoutter representative.

MAINTENANCE INSTRUCTIONS

Assembly and disassembly
● Follow standard engineering practices and
refer to figures/exploded view for the mounting
of component subassemblies.
● Prior to putting the equipment back into
service, check that its main settings have not
been modified and that the safety devices
work properly.
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
WEEE information concerning Waste
of Electrical and Electronic Equipment
(WEEE):
● This product and its information,
meets the requirements of the WEEE
Directive (2012/19/EU), and must
be handled in compliance with the
directive.
● The product is marked with the
following symbol:
- Products marked with a crossed-out
wheeled bin symbol and a single
black bar underneath, contain parts
that must be handled in compliance
with the WEEE Directive.
- The entire product, or the WEEE
parts, can be sent to your "Customer
Center" for handling.
Contact your Desoutter representative or
consult the website "www.desouttertools.
com" to find out where you can recycle
this product.
If needed clean the adaptor external panel
with a dry cloth.
10/2021
Information Regarding Article 33 in
REACH
The European Regulation (EU)
No. 1907/2006 on Registration,
Evaluation, Authorization and restriction
of Chemicals (REACH) defines among
other things requirements related to
communication in the supply chain.
The information requirement applies
also to products containing so called
Substances of Very High Concern (the
"Candidate List").
On 27 June 2018 lead metal (CAS nr
7439-92-1) was added to the Candidate
List.
In accordance with the above this is to
inform you that certain electrical and
mechanical components in the product
may contain lead metal.
This is in compliance with current
substance restriction legislation and
based on legit exemptions in the RoHS
Directive (2011/65/EU).
Lead metal will not leak or mutate
from the product during normal use
and the concentration of lead metal in
the complete product is well below the
applicable threshold limit.
Please consider local requirements on the
disposal of lead at product end of life.
7 / 58
6159922480_04