Conrad 3W 220L Bedienungsanleitung Seite 4

• Connect the supplied USB cable to the USB port (4).
• Connect the other end of the USB cable to the USB port of your USB power supply.
• If necessary, activate the USB power supply.
• The integrated battery in the work lamp will then be charged.
• The charge indicator (3) lights up red during the charging process.
• Once the charging process is complete, the charge indicator (3) lights up green.
• If the work light no longer switches on or the battery warning (2) lights up yellow, the battery
is flat and must be recharged as described.
The operating time with one battery charge varies depending on the model and the
set operating mode (see 'Technical data').
Operation
a) Mounting
• On the front, with the USB port (4), there is a fold-out suspension bracket (1) with which the
work lamp can be suspended.
• Alternatively, there are magnets (7) at the rear of the housing to allow attachment to metal
surfaces.
• If the mounting surface is not magnetic, the enclosed metal plates can be attached to
the mounting surface by means of the screws or adhesive pads enclosed, so that the
magnets (7) can be held in place.
b) Operation
• Set the desired operating mode using the function switch (6).
Off Lamp is off.
ON Light is switched on manually (full brightness)
Auto Lo Automatic mode (half brightness)
Auto Hi Automatic mode (full brightness)
• In automatic mode, the light only switches on when the ambient brightness is low and motion
has been detected by the PIR sensor (5).
• When the battery is flat, the work lamp switches off automatically to prevent deep discharge
and thus damage to the battery.
c) LED indicators overview
LED indicator Colour
Battery warning (2) Yellow
Charge indicator (3) Red
Charge indicator (3) green
Care and cleaning
Disconnect the device from the power supply before cleaning. Do not immerse the
product in water to clean it.
Never use aggressive detergents, rubbing alcohol, organic solvents or other
chemical solutions as these may damage the device or prevent it from functioning
properly.
• Wipe the work light with a dry or slightly damp cloth and then wipe it dry, if necessary.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the house-
hold waste. At the end of its service life, dispose of the product in accordance with
applicable regulatory guidelines.
The in-built rechargeable battery cannot can be removed and must be disposed of
together with the product.
Function
Battery flat, please recharge
battery is charging
Battery charged
Technical data
Charging voltage ..................................5 V/DC
Charging current consumption .............1 A max.
Battery ..................................................Model 3W 220L: Li-ion 1x 3.7 V/2600 mAh
Charging duration . ................................Model 3W 220L: approx. 4.5 h
Operating time . .....................................Model 3W 220L
Brightness . ............................................Model 3W 220L: max. 220 lm
Colour temperature . ..............................6500 K
LEDs . ....................................................Model 3W 220L: 12 LEDs
Colour rendering index Ra . ...................>80
Life . .......................................................25000 h
Weight ..................................................Model 3W 220L: 155 g
Dimensions . ..........................................Model 3W 220L: 171 x 36 x 43 mm
Brightness for automatic switch-on . ......<15 lx
PIR sensor detection angle ..................120°
PIR sensor detection range . .................3 - 5 m
Switch-on duration, automatic mode ....30 s
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in
electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is
prohibited. This publication reflects the technical status at the time of printing.
Copyright 2021 by Conrad Electronic SE.
Model 7W 640L: Li-on 4x 3.7 V/2200 mAh
Model 7W 640L: approx. 14 h.
5 h (full brightness)/30 h (half brightness)
40 days (automatic mode, triggering 10x per day)
Model 7W 640L
8 h (full brightness)/40 h (half brightness)
40 days (automatic mode, triggering 10x per day)
Model 7W 640L: max. 640 lm
Model 7W 640L: 40 LEDs
Model 7W 640L: 400 g
Model 7W 640L: 396 x 36 x 43 mm
2435654_55_v1_1021_02_VTP_m_en