Inakustik AmbienTone No.4 Bedienungsanleitung Seite 11

Step 2:
The wall must first be prepared with metal profiles. Create a recess in a gypsum
plaster board (ceiling or wall), which is approx. 5 mm larger than the AmbienTone
Step 3:
Remove the 2 transport locks located on the back of the loudspeaker and check
that the loudspeaker is
loudspeaker!
loudspeaker all the way around. For the
substructure
relevant manufacturer instructions. Make sure
that the substructure of the plasterboard
covering is such that it will not rattle from the
vibrations of the loudspeaker. For this reason,
make sure that no loose objects are located in
or on the substructure or are in contact with its
surface and ensure that nothing is touching the
back of the loudspeaker.
functioning correctly.
Place the loudspeaker in the prepared recess.
In order to achieve an optimum bond between
the AmbienTone
smoothing
directions of the filler manufacturer with regard
to edge preparation of the plasterboards you
want to spackle. (e.g. folding of the edge
where the speaker is inserted)
and covering, observe
Make sure to connect
loudspeakers
cement, please observe
the
the
and the
the
11