Werbung
Verfügbare Sprachen
Verfügbare Sprachen
AMBIEN
AmbienTone-Assembly Instructions
AmbienTone is a flat panel loudspeaker in a modified gypsum plasterboard. It is
installed into a drywall constructions. And in just a few work steps.
Once connected, fitted and spackled, AmbienTone can be wallpapered over, painted
and even plastered over. A coat of up to a thickness of 2 mm will result in only a
minimal loss of sound quality.
Installation guide
Note: This is a brief, general description of the procedures. Fitters and contractors
must take the individual materials and circumstances on site into consideration!
Step 1:
Perform function check before fitting into drywall constructions.
•
Carefully inspect the loudspeaker system for exterior defects and damage.
•
Remove the 2 transport locks on the rear of the loudspeaker system.
•
Check whether there are any loose parts in the loudspeaker system. To check
•
that the loudspeaker system is working properly, pick up the loudspeaker
system in both hands and shake it in all directions so that any loose parts
within the loudspeaker will make a noise as they hit the sides. Any noise of
loose parts indivates a defect of the speaker.
Check the electrical functions of the loudspeaker system. To do this, connect
•
the loudspeakers to an audio amplifier and play a known audio test signal
over them. Pay attention to the reproduction of the known test signal. In
particular, make sure there are no unwanted side noises and distortions.
Fit the loudspeaker system according to the installation instructions.
•
Pay attention to the polarity (+/-) when connecting the cable.
•
10
TONE
Werbung
