WXM RST-Serie Benutzerhandbuch Seite 17

Folding the kick scooter
In order to fold the kick scooter, you should first release the folding lock (element
no. 12) by pulling the lever away from the kick scooter. Next, press the fast-folding
system lever (element no. 13).
WARNING: You must hold the handlebar with the other hand so that after you press
the folding button it does not fall – it could cause harm to the person folding the kick
scooter or damage the product.
WARNING: Remember to close the folding lock after assembling the kick scooter.
Carry strap
The carry strap included in the set should be connected to the kick scooter in two
places on the handlebar. First loop is located near the attachment for handle grip
and carry strap (see element no. 2), the second one is located next to the front wheel
fender/mudguard.
WARNING: The strap should be connected to the kick scooter only when carrying the
product. The strap should be detached and safely hidden when using the kick scooter.
Wheel replacement
I. In order to take the front wheel off, remove the fastening screw using two hex
keys – one to hold the fastening screw in place on one side of the wheel and the
other to remove it on the other side.
II. In order to take the rear wheel off on which the brake disc is located, remove the
tightening screws just like in the front wheel – using two hex keys. Next, take the
brake disc off by removing three tightening screws using a hex key.
WARNING: One of the sides of the rear wheel is designed flat in a way allowing
the brake disc to fit well against it. When assembling the wheel, pay attention so
that the flat side of the middle of the wheel is connected to the brake disc.
Bearing maintenance
Lubricating oil should be used for bearing maintenance. Replace a bearing in case
it gets knocked off the wheel axis. In case of damage, replacing the whole wheel with
a new bearing is recommended.
KICK SCOOTER USER'S MANUAL
• In order to put the kick scooter in motion, when standing on the scooter with one
foot and both hands placed on the grips push yourself off the ground with the
other foot analogically, just like using a skateboard. The kick scooter will stay in
motion if the foot is used to push off the ground in a regular repeated manner.
• Change of direction takes place through turning the handlebar in the desired
direction. You should remember that turning the handlebar suddenly may result
in loss of balance and damage to health.
• You can use one of the two brakes in order to stop or slow down the kick scooter.
17