REDATS H-320 Bedienungsanleitung Seite 9


Remove the Oil Fill Plunge located on the back of the Jack to expose the Oil Fill Hole.

Open the Release Valve located on the front of the Jack, above. Insert the Jack Handle into the Plum Core.
Slowly pump handle to force air out of the Oil Fill Hole.

As soon as the oil starts to come out of the hole, stop pumping. Replace the Oil Fill Plug. Close the Release
Valve.

Check the oil level. It must be just below the Oil File Hole. If necessary, fill with high quality hydraulic oil.
Maintenance

Caution: Always release load from the Shop Press before performing any inspection, maintenance, or cleaning.

Before each use, inspect the general condition of the Shop Press. Check for structural failure, loose, cracked,
bent or damaged parts, misalignment or binding of moving parts, and any other condition that may affect its safe
operation. Do not use damaged equipment.

To prevent rust, coat all exposed surfaced surfaces with a lightweight oil.

Always keep the Arbor Plates and Press Apron are clean and free of oil and other lubricants.

To clean, wipe with a clean, damp cloth.

When storing, keep the Shop Press covered with a clean drop cloth in a cool, dry location.
INSTRUKCJA OBSŁUGI/USER'S MANUAL/BEDIENUNGSANLEITUNG - redats H-320
9