DALAP 100 ELIS Bedienungsanleitung Seite 4

EN
Basic wiring information:
1) Switch off the electrical circuit you will be working on.
2) Unscrew the screw on the side of the front panel and remove the cover, under which there is a terminal strip with
three terminals.
3) The terminals are labelled with the letters T (interruptible phase), L (fixed phase) and N (neutral phase).
4) Carefully review the wiring diagram in PIC 7a.
5) Pull the power cables through the rubber bushing and connect them to the terminal strip per the diagram.
6) Once connected to the terminal strip, fasten the power cables with a clamp near the bushing (PIC 1).
7) Set the timer (Time).
8) Set the jumpers for the selected mode (see below)
9) After installation is complete, connect power and turn on the fan.
Timer settings (PIC 3.)
The timer is located under the front panel of the fan next to the terminal strip and is labelled as "Time". Use a small
screwdriver and carefully turn the adjustment screw to the left or right to set the timer from 15 seconds to 45 minutes.
MODE 1 – activation using a separate switch with time delay shut-off
Wiring: From the separate switch, connect the black wire to the L terminal. Connect the brown switched wire to the T
terminal and the blue neutral wire to the N terminal. Set the jumper in position 5a.
The fan is activated by pressing the separate single-pole switch and then runs continuously. Once the switch is turned
off, the fan continues to run for the time set on the timer and then turns off.
MODE 2 – activation after lights are turned off (PIC 7a and PIC 5b)
Wiring: From the light switch, connect the black wire to the L terminal. Connect the brown switched wire to the T
terminal and the blue neutral wire to the N terminal. Set the jumper in position 5b.
The fan is connected to the light switch and is activated once the light is turned off and runs for the time set on the timer.
ELIS Z (models with timer)
4