Intended Use - CTC EcoTouch 500 DT Serie Planung Und Installation

2 Safety

Intended use

Environmental protection
Hazards
Copyright © 2021 av: CTC Professional. Kan komma att ändras.
The hydraulic station contains the necessary components for the connec-
tion of the heat pump to the heat source and the heating system in the do-
mestic environment.
Project planning of the heat source system must be performed in compli-
ance with the technical information provided by CTC for layout of heat
source systems.
Heat pump shall only be turned on after the refrigerant connections are
completely filled, and the other hydraulic circuits are completely filled and
vented, and all electrical connections are properly completed.
Commissioning may only be carried out by trained professionals. Damages
caused by non-compliance with above mentioned items are not covered by
the warranty (see enclosed Exclusion of Warranty).
•
Observe the regulations regarding waste avoidance and proper waste
recycling or disposal when performing any kind of work on and with the
hydraulic station and heat pump.
•
Ensure that particularly during installation and maintenance work, as
well as when placing out of operation, groundwater pollutants such as
grease, oils, refrigerants, solvent-containing cleaning fluids, etc. do not
contaminate the ground or enter into the sewer system!
These substances must be collected, stored, transported, and dis-
posed of in suitable containers.
Observe the following points to avoid life-threatening injuries and damages
to the hydraulic station and heat pump during operation:
Risk of death by electric shock!
Do not use water or other liquids to clean the system!
Keep all electrical supply units locked at all times!
Any work on the electrical equipment of the heat pump shall only be per-
formed by professional electricians!
Caution! Danger of suffocation!
The packaging is not a toy. Dispose of the packaging in an environmentally
friendly way.
40