Troubleshooting; Installation - Lagan HGC3K Gebrauchsanleitung

ENGLISH
Removing the residues and stubborn
residues
1. Food containing sugar, plastics, tin foil
residues should be removed at once,
best tool for cleaning glass surface is a
scraper (not included with the
appliance). Place a scraper on the glass
ceramic surface at an angle and remove
residues by sliding the blade over the

Troubleshooting

Warning! Refer to Safety
chapters.
What to do if...
Problem
The cooking zones are not
functioning.
The residual heat indicator
does not activate.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.

Installation

Warning! Refer to Safety
chapters.
2. Limescale rings, water rings, fat
Possible cause
The desired power setting is
not set.
The fuse in the house electri-
cal installation (fuse box) has
been tripped.
The cooking zone was only
on for a short time and is
therefore not hot.
surface. Wipe the appliance with a
damp cloth and a little washing up
liquid. Finally, rub the appliance dry
using a clean cloth.
splashes, shiny metallic discolorations
should be removed after the appliance
has cooled down using cleaner for glass
ceramic or stainless steel.
Set the power setting.
Check the house electrical
installation fuse. If the fuses
trip a number of times,
please call an authorized
electrician.
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
10
Remedy