Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Make sure both height adjustment locks are tightened well, as the dryer
bonnet is large and heavy.
4. Make sure that the temperature dial is set to OFF. Plug the appliance to
the mains. Use the retaining clip to secure the power cord.
5. Lower the guard. The appliance will not start with the front guard lifted.
CAUTION! Lifting the front guard while the appliance is in operation will
turn it off.
6. Adjust the air louvre as required (it is beneath the front guard, inside of
the bonnet).
7. Set the desired operating mode (turning the temperature dial to any
setting other than OFF starts the appliance):
COOL: cold air – used in the last step of hair drying to give enough shine
•
and smoothness to the hair, with proper fixing of the styling.
•
LO HEAT: for drying slightly moist hair and any other treatment,
including strengthening and nourishing of hair. The LO HEAT mode is
also used for drying wigs and hair extensions.
•
HI HEAT: for drying very wet, natural hair. If the hair is partially dry,
switch the temperature dial to LO HEAT.
8. To turn on ionisation, turn the ion mode switch ON. Ionising is used for
general nourishment of hair and helps to minimise electrostatic charging
of hair, leaving it shiny. Ionising also reduces the time to dry the hair.
To turn off ionisation, turn the ion mode switch OFF.
9. Set the temperature dial to OFF to turn off on the appliance.
3.4. Cleaning and maintenance
a)
Before cleaning, adjustment or replacement of accessories, and when the
appliance is not in use, unplug the power cord from the mains and leave the
appliance to cool down completely.
b)
Use non-corrosive agents only for cleaning the surfaces.
c)
After each cleaning, dry all components well before the appliance is used
again.
d)
Store the appliance in a dry and cool place, protected from moisture and direct
sunlight.
e)
Do not spray the appliance with a stream of water and do not immerse it in
water.
f)
Keep water and liquids away from the air inlet and outlet openings.
g)
Regularly inspect the appliance for technical defects and damage.
h)
Clean with a soft, damp cloth.
i)
Do not clean with any sharp and/or metal implements (e.g. a wire brush or a
metal scraper) as these may damage the surface of the appliance.
Werbung
Inhaltsverzeichnis
