Hyundai ROB010 Bedienungsanleitung Seite 30

Food processor control
– Tilting the multifunctional head downward/upward (fig. 2, 5)
When you press button A1 and slightly will lift the head upward. When you press button
A1 further and pushing the unit down will tilt the head downward.
– On/off switching of the food processor
Before you switch on the food processor, plug the power cord A6 into electric socket.
Then switch on the food processor by rotating the speed regulating knob A2. After you
finish working, switch off the food processor by rotating the speed regulating knob to
position 0.
– Speed control
Speed is controlled by setting the speed regulating knob A2 to the desired position
within the interval 1 - 2 - 3 - 4 - 5 - 6. For short operation time at the maximum speed,
the regulating knob can be set to position "PULSE". The regulating knob must be held
by hand in this position. Releasing the regulating knob will return it to position 0 and stop
rotating.
Food processing time depends on the volume, type and quality of the processed
ingredients. It usually takes several minutes under normal conditions.
III.2. WHIPPING, MIXING WHISK AND KNEADING HOOK
Description (Fig. 1)
C1 – Mixing whisk
C2 – Whipping (wire) whisk
– With regard to the bowl size, please note that the food processor is not able to sufficiently
whip / knead very small amounts of food. For optimum results input at least 300 g of food
(if you are whisking egg-whites, use at least 4 eggs).
– Never fill the bowl with water or other liquid to the maximum level. Respect the maximum
allowed capacity (see the Table of Use, Chapter IV.).
– First switch „0" / off the food processor, then tilt its multifunctional head upward.
– When tilting the multifunctional head upward, control / slow down its rotation by hand.
– The food processor is fitted with a security safeguard, which will switch off the motor once
the multifunctional head is tilted upward (during operation). After the head is titled back
into the working position, the motor will remain switched off. To turn it on, you have to
return the speed regulating knob A2 to position „0".
Assembly for work with attachments
Assemble the food processor according to instructions in Figure No. 2, 3, 4, 5 and 6 by lifting
the multifunctional head up. Then put the bowl with the food in the lower section of the food
processor. Then install the desired adapter on the mount, and tilt the multifunctional head
downward to the working position. Apply reverse sequence to remove/exchange the adapter.
Safety hints and tips
30 / 49
PUSH
C3 – Kneading hook