Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RADIO: WIRELESS DOUBLE PUSH-BUTTONS FOR CENTRALIZATION
ABE2BPP ON/OFF
5454815 Wireless double push-buttons for light
ABE2BPP UP/DOWN 5454816 Wireless double push-buttons for roller
Technical specifications:
- Mains voltage: 230V~ +10% -15% - 50Hz
- Module consumption: < 0.3VA - < 0.1W
- Max. 4 receivers per transmitter channel
- Operating temperature: from -10 to + 50°C
- IP30 protection
- Max. relative humidity 80%
- Radio frequency band: 2400 - 2480 MHz
- Maximum radio power transmitted: 10mW
- Transmission: two-way
- Dimensions of buttons (L x A) 22,5 x 45 mm
- Dimensions of module(L x A x P) 22,5 x 50 x 46,8 mm
WIRING THE ABE2BPP TRANSMITTER
N L
5454815
DIRECT MODE
1
Press the pushbutton to be connected on the transmit-
ter (E) 5 times*.
The transmitter LED, located inside between the 2 but-
ton covers, will start flashing for 30 seconds, indicating
that the system is waiting for connection.
* Each press must last less than 0.7 seconds.
Led
5454815
The LED will light up on transmitters only if radio transmission was successful.
All YOKIS transmitters are compatible with YOKIS receivers (Relays, dimmer, Shutter Modules and dimmer).
DS1054-066A
control/centralization
shutter control/centralization
N L
Led
5454811 / 5454813
Simply repeat the same procedure to delete a connection.
RADIO RANGE:
Power range:
• Inside
perpendicular crossing of main wall or
ceiling
• 250m in open range
(Range may be reduced by presence of
metallic elements, crossing of walls or
partitions)
RADIO TRANSMISSION:
The transmitter LED lights up only if
radio transmission was successful.
Adding an intermediate receiver will allow
to solve a problem of insufficient range
(see § "How to increase the range").
5454816
2
Briefly press the top of the receiver at the "Connect"
label (see Figure) while the transmitter LED is blinking.
The transmitter LED will stop flashing.
Warning: the receiver must be powered.
5454816
P8
GB
100m²
apartments
The module must only be
installed by qualified personnel
in accordance with national
installation
regulations.
comply with safety regulations,
the module must be connected
to an electrical line protected
upstream by a C-curve 10A
circuit breaker.
Led
5454812
with
To
Led
Werbung
Inhaltsverzeichnis
