Blaupunkt 5WK610FF0L Bedienungsanleitung Seite 42

• To select the temperature zone, press (H) once, upper zone will flash, (H) key
pressing again to switch it to lower zone. Setting temperature could only be set under display flash
status.
• You can touch key "+" (C) and key "-" (B) to set the internal temperature for the
selected zone. The degrees indicators will appear in the display window marked
and for lower zone.
• When the unit is plugged in for the first time, the LED readouts will show the original
temperature set previously. Touch the "+" (C) and "-" (B) mark once of each compartment to set
the desired temperature.
• The temperature will increase by 1°C or 1ºF if you touch the "+" (C) mark once, or
the temperature will decrease by 1°C or 1ºF if you touch the "-" (B) mark once.
When the surrounding temperature is 25℃ and the wine cooler has no bottle
loaded, it will take around 10 minutes to increase the wine cooler's temperature from
5℃ to 12℃. Under the same circumstance, it will take around 20 minutes to decrease the
wine cooler's temperature from 12℃ to 5℃. The less the temperature span is, the less
time it will take. The setting temperature of upper zone should be lower than the setting
temperature of lower zone
Temperature display
Display show at its setting.
To view the actual temperature in either zone at any time, touch key (B) and key (C) for 3
second, the display will display two zone's actual temperature with flashing, and it will quit by holding
stop.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the
inner temperature will not immediately be the temperature setting on the display. Indeed, it is
necessary to wait a few hours for a temperature adjustment of the wine cellar in order to have a
homogeneous temperature. To avoid excessive condensation when the ambient temperature is above
28°C, do not lower the temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is
imperative to wait 5 minutes before turning it on again.
Temperature alarm
The alarm will sound and the temperature display will flash when:
- The temperature in one of the zones rises or falls outside the temperature
range (5-12°C or 12- 20°C)
- You switch the appliance on, if the temperature inside the appliance is very
different (+/- 4°C) from the temperature set after 7 hours working
- Too many items have been put into the unit at one time, and the temperature
inside the appliance is very different (+/- 4°C) from the temperature set after 7 hours working
- The door has not been closed tightly
Door alarm
If the door has been left open for more than 60s, the alarm will sound. Once the set
temperature has been reached in the appliance, the alarm stops and the relevant temperature display
stops flashing. However, if the noise disturbs you, you can switch the alarm off before this if you wish
by pressing the key I once. The alarm will stop. The relevant temperature display continues to flash
until the set temperature has been reached. The display then lights up constantly and the alarm system
is fully active again.
EN
for upper zone