Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
Push the screw D, leading with the plastic
connector, into the housing
the end stop.
2
Set the blade E, with the smooth cutting side
outwards (inscription legible), on the square
end of the screw.
3
Position the desired perforated disc
axle of the screw.
IMPORTANT:
The notch of the perforated disc must
point downwards and sit over the small raised area
in the housing! See detail X.
INFO:
Both sides of the perforated disc can be
used.
4
Screw the sealing ring
housing and tighten by hand.
5
Attach the filling hopper
TIP:
It is better not to attach the filling hopper until
after the attachment is fitted to the drive unit.
Mounting/removing the attachment
See operating instructions for the Drive Unit.
Processing ingredients
Rotating parts can cause injury!
CAUTION
•
Never put your hand into the attachment when
the motor is running.
•
Never insert the food to be processed into the
appliance by hand. Always use the pusher A.
•
The universal mincer attachment may only be
operated when it is completely assembled and
the sealing
ring G
is screwed on tight.
•
Before using for the first time, thoroughly
clean all parts of the attachment (see section
Cleaning).
•
To operate the drive unit, see the operating
instructions for the Drive Unit.
•
Insert the ingredients to be processed into the
filling opening of the attachment in portions.
Push them down using the pusher A.
INFO:
Excessive pushing does not speed
the process up.
Subject to technical changes without notice; no responsibility is accepted for the accuracy of this information.
C
until it reaches
F
on the
G
clockwise onto the
B
onto the housing.
Cleaning
Dishwasher can cause damage!
Only the stainless steel attach-
ments (476 500 and 480 500) are
Note
dishwasher safe!
Attachments are not dishwasher-safe. Only clean
the attachments using lukewarm water and was-
hing-up liquid.
•
Remove the attachment from the drive unit
before cleaning.
•
Disassemble the universal mincer attachment
and clean it with lukewarm water and was-
hing-up liquid.
•
Clean the blade and perforated disc separately
and allow to dry thoroughly.
•
Rub a little cooking oil or fat onto the blade and
perforated disc.
Storage
Store the appliance in its original packaging, in a
dry, dust-free and cool place that is out of reach of
children.
Accessories for the universal mincer
attachment
This accessory can only be combined with the
universal mincer attachments 476 100, 476 500,
480 500 and 862 260!
Attachment
Processing notes
Special grater attachment
ideal for finely grating hard
foods such as nuts, almonds,
hard cheeses, chocolate,
bread, etc.
220 000
5
Werbung
Inhaltsverzeichnis
