Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PARALLEL GUIDE
1
Attach the parallel guide
7
as shown
and set the desired parallel distance.
If the tool is not in use the parallel guide
can be used as a blade guard.
REBATING
1
Attach the rebating depth guide
shown and set the desired rebating
distance from 0 to 15.5 mm.
DEPTH ADJUSTMENT
1
To set the desired planing depth from
0 - 3 mm, rotate the depth adjustment
knob 3.
Each click adds / decreases 0.1 mm.
BLADE REPLACEMENT
1
Use the 8 mm wrench to loosen the
three screws.
Caution! Make sure the tool is
switched off and unplugged.
3
Replace the blade or the complete
blade assembly and slide it back into
the tool so that it runs freely.
Caution! Make sure the blade is
placed in the correct position.
122
EN
BEVELING
2
The three V-grooves in the front of
the base
plate 6
allow quick bevelling.
Place the V-groove of the desired size
on the edge and guide it along.
5
as
2
Set the desired distance on the parallel
guide 7
in order to make rabbets. Plane
as often as necessary to achieve the
desired rabbet.
2
The current depth adjustment can be
checked on the indicator of the depth
adjustment knob 4.
2
Open the blade cover and slide out the
blade assembly.
Caution! The blade is sharp. Use
protective gloves.
4
Adjust the height of the blade assembly
with a hex key and securely tighten the
three screws loosened in step 1 .
There are two blades on the spindle!
Caution! Always use identical
blades and blade assemblies.
1
1
1
1
1. 1.
2. 2.
3. 3.
3
2
2
2
2
4
1. 1.
2. 2.
EN
123
Werbung
Inhaltsverzeichnis
