Sharp EM-PH1A Bedienungsanleitung Seite 4

2
This Phone Holder suits the Sharp EM-KS1 and EM-KS2 e-scooters and it
is also suitable to most other e-scooters with handlebar diameter of 15 to
22 mm. It is suitable for most phones with screen size ranging from
4.7 to 6.5 inches.
What's in the Box
• Phone Holder
Construction
Identification of Parts
1. Clamp
2. Securing Screw
3. Bottom Pads
4. Clamp Release Levers
1
4
3
3
Ball shaft buckle
1. Anti-slip rubber pad
2. Clamp
1
4
2
1
2
Putting your Phone Holder Together
The phone holder comes in two parts, the holder and the clamp. These
need to be assembled before attaching to your e-scooter. To assemble the
unit, follow the instructions as below:
1. Nut
2. Clamp
3. Phone Holder
4. Screw Thread
3
Fit the clamp to the holder so that it is secure. It is possible to move the
phone holder to various angles. When the desired angle is achieved, always
ensure that the nut is tightened so that the phone holder does not move.
5. Assembled phone holder and clamp.
2 1
4