KERN&SOHN KFB-TM Betriebs Und Installationsanleitung Seite 389

P2 mode SiGr
Konfigurations-
daten
dUAL 1
dUAL 2
P3 OTH
LOCK
s. Kap. 7.10 / 7.11
ANM
P4 tAr
Restricted taring
range
KFB/KFN-TM-BA_IA-e-1220
Single-range balance
COUNT Display internal resolution
DECI Position of the decimal dot
Div. Readability [d] / verification value[s]
CAP Balance capacity [Max]
noLin
CAL
LinEr
GrA Not documented
Dual range balance
Balance with two weighing ranges and different maximum load
and weighing ranges and interval sizes but only one load-
supporting pan, whereby each range extends from zero to the
respective maximum capacity. When load is removed, weighing
scales will remain in 2nd range.
COUNT Display internal resolution
DECI Position of the decimal dot
div 1
div.
div 2
CAP 1
CAP
CAP 2
noLin
CAL
LinEr
GrA Not documented
Multi-interval balance
Weighing scales with one weighing range subdivided into partial
weighing ranges, each providing a different scale interval. The
scale interval depends on the applied load and is automatically
changed during loading and unloading.
COUNT Display internal resolution
DECI Position of the decimal dot
div 1
div.
div 2
CAP 1
CAP
CAP 2
noLin
CAL
LinEr
GrA Not documented
on Keyboard lock enabled
off Keyboard lock disabled
on Animal weighing enabled
off Animal weighing disabled
,
Press the current setting will be displayed. Using the
navigation buttons (see chap. 2.1.1) select the desired setting, the
active digit is flashing.
Confirm input by .
Adjustment, see chap. 6.9
Linearisation, see chap. 6.10
Readability [d] / verification value [e]
1. weighing range
Readability [d] / verification value [e]
2. weighing range
Weighing scale capacity [max]
1. Weighing range
Weighing scale capacity [max]
2. Weighing range
Adjustment, see chap. 6.9
For linearization, see chap. 6.10
Readability [d] / verification value [e]
1. weighing range
Readability [d] / verification value [e]
2. weighing range
Weighing scale capacity [max]
1. Weighing range
Weighing scale capacity [max]
2. Weighing range
Adjustment, see chap. 0
Linearisation, see chap. 6.10
41