Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
INITIAL SETTINGS
After connecting the device and installing the APP, tap the
"menu" button, ref.2, and select the "
Set the following data:
- Battery 1 installation/replacement
- Battery 2 installation/replacement
- Battery 1 capacity (Ah)
- Battery 2 capacity (Ah)
Confirm the entered value by tapping "Save" and then
"Confirm".
MENU
To open the menu, tap the corresponding button, ref.2, on the
home screen.
The following options are available in this menu:
Advanced information (to view system information):
Errors – this section indicates any issues
concerning the two batteries connected to the
device.
Batteries installation date - it indicates the set
battery installation date.
Battery capacity – it indicates the set battery
capacity in "Ah".
F
ull charges
number
charge
battery
F
ull discharges
full discharge
battery
Batter
ies
health – it indicates the battery health
status, expressed as a percentage (%).
Instructions (BDS180 Wi-Fi connection guide)
Configuration
- Battery setup
Battery 1 installation/replacement – to set the date
of installation/replacement of battery 1.
Battery 2 installation/replacement – to set the date
of installation/replacement of battery 2.
Battery 1 capacity (Ah) – to set the capacity of
battery 1.
PASSWORD RESET
If you forgot the password that allows you to connect to the
BDS180 via the APP, hold the "RESET" button (ref. 2 – figure
1) to reset the password to the default value (00000000).
24
Configuration
– it indicates the number of full
cycle
s.
number
– it indicates the number of
cycles.
It is also recommended to set a new password and adjust
" option.
the power of the Wi-Fi signal:
- New Password
-
WI-FI
Tap "Save Wi-Fi
apply the changes.
NB: each time the password is changed, the mobile
device must be paired again with the BDS180.
Battery 2 capacity (Ah) – to set the capacity of
battery 2.
Tap "Sav
e Configuration
changes.
WI-FI
New_Password – to set a new password.
Confirm_Password – to confirm the newly set
password.
WI-FI
(3 power levels available)
Tap "Save Wi-Fi
to apply the changes.
Firmware update.
To update the firmware of the BDS180 to the latest
available version, tap "Update" and then "
Do not turn off your device during the update; this may
take a few minutes. Once the update is complete, a
message will appear on the screen and you will need to
pair again your mobile device with the BDS180.
Manual (to consult the Instruction Manual of the
BDS180 device)
CBE technical support contact.
Once the reset is complete, open the "Setup" menu and
enter a new password. Update the password on all the
mobile devices paired with the BDS180.
Power (level 1, 2 and 3)
Configuration
" and then "Confirm" to
" and then "Confirm" to apply the
power – to set the power of the Wi-Fi signal
Configuration
" and then "Confirm"
OK
".
Werbung
Inhaltsverzeichnis
