Samsung SWA-W510 Bedienungsanleitung Seite 6

5. If the SWA-W510 does not connect, take
the necessary steps according to the LED
Indicator's status
LINK (Blue) On : Successfully connected (normal
operation).
LINK (Blue) Blinking : Recovering the connection.
• Check if the power cable attached to the main
Soundbar unit is connected properly or wait about
5 minutes.
• Repeat steps 2 through 4.
STANDBY (Red) On :
• Standby (with the Soundbar main unit turned off).
‒ Check if the power cable attached to the main
Soundbar unit is connected properly.
• Connection failed
‒ 1. Press the ID SET button on the back of the
Surround Speakers with a pen tip for 5~6
seconds until the LINK LED indicator blinks
(in Blue).
Rear of Subwoofer
‒ 2. Repeat steps 2 through 4.
Red and blue Blinking : Malfunction
• See the contact information for the Samsung
Service Centre in this manual.
03 COMPATIBLE MODELS
• Compatible with select Samsung Soundbar. Please
visit the Soundbar product page at www.samsung.
com/support for more information.
• Compatible model list is subject to change without
further notice.
04 OPEN SOURCE LICENCE
To send inquiries and requests for questions regarding
open sources, contact Samsung Open Source
(http://opensource.samsung.com)
05 IMPORTANT NOTES
• An administration fee may be charged if either
(a) an engineer is called out at your request and there
(b) you bring the unit to a repair centre and there is
• You will be informed of the administration fee
amount before a technician visits.
5 sec
ENG - 6
NOTICE
ABOUT SERVICE
is no defect with the product (i.e. where the user
manual has not been read).
no defect with the product (i.e. where the user
manual has not been read).