Battery Operation; Mains Operation - Hama 00176590 Bedienungsanleitung

5. Installation
Warning - installation with adhesive
• All parts are suitable only for use indoors. Do
not install outdoors.
• Be aware that the intended mounting surface
must be free from dust and grease. Use a suita-
ble cleaner from a specialist retailer for this.
• Be aware that the adhesive pads are intended
to be permanent. Carefully pull the adhesive
pad off the mounting surface to remove it.
• Various environmental influences, such as mo-
isture in the air, sunlight, cold, etc., can impair
the long-term stickiness of the adhesive pads.
• Possible residue on the mounting surface
after removal of the adhesive pads cannot
be ruled out!
Warning – Installation
• Before mounting, check that the wall you
have chosen is suitable for the weight to be
mounted. Also make sure that there are no
electric, water, gas or other lines running
through the wall at the mounting site.
• Do not mount the product above locations
where persons might sit or stand.
• Buy special or suitable installation material
from a specialist dealer for wall-mounting.
• Never apply force during assembly.
• If in doubt, have this product installed by a
qualified technician - do not attempt to install
it yourself.
3
• The low weight of the product means that a screw
with a plug or a nail are all that is needed to
attach it at the required installation point.
• Depending on the design of the installation point
(e.g. wood), you can also attach the product
directly onto a screw or nail, for example, without
pre-drilled holes.
• Ensure before hanging the siren up that the screw
or nail is securely fixed.
6. Commissioning
The siren can be used both in battery and mains
operation.

6.1 Battery operation

• Turn the cover on the back of the siren clockwise
to open the battery compartment.
• Remove the spent batteries and dispose of them
if required. Now insert two CR123A batteries
(not included). Take care to ensure the correct
polarity as shown in the diagrams in the battery
compartment.
• Replace the cover on the back of the sensor
and turn it this time anticlockwise until it locks
into place.
• The LED on the motion detector now flashes
quickly.
• If the LED does not flash quickly, remove the cover
from the back and hold the pairing button for
around 5 seconds.

6.2 Mains operation

Warning
When supplying power via the micro-USB port,
there must no batteries in the siren.
• For operation via USB, connect the supplied
micro-USB cable with the micro-USB socket and
a suitable USB power supply unit (not included in
the scope of delivery).
• Connect the power supply unit to a properly
installed socket.
• Only operate the product from a socket that has
been approved for the device. The socket must
be installed close to the product and must be
easily accessible.
6.3 Integrating devices into the Hama Smart
Home (Solution) app
• Press and hold the pairing button for around 5
seconds. The LED starts to flash red quickly. If it
flashes slowly, press and hold the button again for
approx. 5 seconds.