Prophete 5440 Bedienungsanleitung Seite 22

SWITCHING OFF AND STORING THE
PRESSURE WASHER
1. Press the ON/OFF button once to switch off the Pressure
2. After switching off the Pressure Washer, pull on the
3. Remove the water hose from the Pressure Washer.
4. Remove the manual spray gun from the water hose.
5. Allow the last traces of water to drop from the water hose.
6. Dry all parts with a clean lint-free cloth, or allow to dry off
7. Once all parts are dry, you can stow them in the Pressure
STORAGE
1. Do not store the Pressure Washer in either a too hot or
2. Please store the Pressure Washer at a temperature
3. The battery should be stored with a minimum residual
108-01-25_BDA-Druckreiniger_10x14_GB.indd 10
Washer. Alternatively, you can press down the ON/OFF
button for approx. 5 seconds – this activates the ON/OFF
circuit breaker for transport. You can deactivate the circuit
breaker by connecting the Pressure Washer to the charger.
lever of the manual spray gun until the last of the pump
pressure has escaped and the water flow has completely
stopped.
By pressing the lever of the manual spray gun again, the
rest of the water will drain off.
in the open air.
Washer.
too cold environment. Furthermore, the storage location
should be dry, cool, well ventilated and not be subject to
direct sunlight.
between 0 °C and 20 °C. At temperatures below 0 °C,
freezing can cause damage to the device.
capacity of 50%. In this regard, we recommend that the
battery be charged for approx. one hour after each use.
4. If t
CARE
Genera
Pflege u In princ
lubrican
Allgeme
the con
Grundsä
movable
von Zeit
Handspr
from tim
Water f
Check t
Wasserf
has bee
Überprü
sufficien
Nur so k
Manua
Handspr
If the no
Sollte die
thereby
diese zu
immedi
Schalten
Otherwi
verbleib
too high
Reinigen
Switch
manual
Remove
Now ca
paper c
02.08.2019 10:36:55
ba
(ch
nd W
in
ätzli
zu
ritzp
ilte
üfen
ann
ritzp
e Sp
rei
n Sie
end
n Sie