Venga VG VT 3010 Bedienungsanleitung Seite 8

ASSEMBLY
•
Assemble the cross base by placing the upper part above the other (14) and
tightening the four provided base screws (12).
•
Attach the 4 anti-slip plastic covers (15) to the 4 sides of the cross base.
•
Use the base plastic cover (13) to attach the tube (11) properly and cover the base.
•
Insert the fan body in the tube and tighten the tube screw (10) to secure it.
• The height of the fan can be adjusted by using the height adjustment ring at the
junction of the tubes.
•
Insert the rear grid (5) the grid locking nut (4) the propeller (3), the propeller locking
nut (2) and the front grid (1) on the axis (6).
•
Close and secure by firmly tightening the grid screw and nut through the closing hole.
•
To adjust the tilt, gently push the motor block (7) to the desired vertical position while
holding the fan body with the other hand.
OPERATING INSTRUCTIONS
•
Place your fan on a flat and dry surface and plug it into a suitable mains socket.
•
Make sure the fan is fully assembled before switching on.
• Choose the desired SPEED using the buttons (9) on the fan body to start the fan.
0 = OFF
1 = soft
2 = moderate
3 = strong
• Use the SWING knob (8) to start or stop the oscillation function.
•
Press the «0» button to stop the fan.
Caution: Never touch the blade with hand or any other objects when the fan is operating.
CARE AND CLEANING
Caution: Always disconnect the fan from mains socket before cleaning.
The propeller blade may have sharp edges. Handle with extreme care.
• Use only a soft damp cloth to clean the fan.
•
Never spray the appliance with liquids or submerge it in water or other liquid.
• Never allow water to drip into the motor block.
• Never use gasoline, paint thinner or other chemicals to clean the fan.
•
If it will not be used for a long period of time, store the fan in a dry place, in its original
box to protect it from dust and humidity.
VG VT 3010 8