Technical Parameters - YATO YT-82168 Originalanleitung

TOOL CHARACTERISTICS
The hand-held wood power saw is a power tool designed for cutting surfaces made of wood or materials of wood processing such
as plywoods, particleboards, MDF panels etc., using saw blades. The power saw allows wood cutting in a vertical plane of the
cut surface in the adjustable cutting depth range as well as at an angle in the adjustable range from 0° to 45°. The cut can only be
made along a straight line. Do not cut along the curve (e.g. circle), as this could result in an accident or damage to the saw blade
and power tool. The power saw can also be used for plunge cutting, which does not start with the edge of the material being cut.
The correct, reliable, and safe operation of the tool depends on its proper use, therefore:
Read this entire instructions manual before the fi rst use of the tool and keep it for future reference.
Caution! Under no circumstances the tool can be used without the saw blade guards and splitting wedge installed.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.
EQUIPMENT
The factory packaging should contain:
- power saw
- guide with rods

TECHNICAL PARAMETERS

Parameter
Catalogue No.
Mains voltage
Mains frequency
Rated power
Insulation class
Rated speed
Max. cutting depth (0°/45°)
Saw blade
Outer diameter
Inner diameter
Max. thickness
Weight
Noise level
- sound pressure L ± K
pA pA
- sound power L ± K
wA wA
Vibration level a ± K
h
Protection rating
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
O R I G I N A L
14
GB
Unit
[V~]
[Hz]
[W]
[min ]
-1
[mm]
[mm]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82168
220 - 230
50
1300
II
2000 - 5000
55/38
165
20
2.4
4.7
89 ± 3
100 ± 3
1.4 ± 1.5
IPX0