Seite 7
EN:Firstly, Install the screws on the beam, but do not tighten them. After the uprights are tightened, then tighten the screws all. If the hole position is not aligned, move the uprights to adjust the position. DE:Installieren Sie zunächst die Schrauben am Träger, ziehen Sie sie jedoch nicht fest.
Seite 19
EN:1.S and T are divided into left and right directions, identification method: take apart the four zippers, and install S/T in a single piece. The iron hook on S passes through the hole on T and hooks on the small hole of the upright.