Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Insert the adaptor's connector into the DC jack input at the back of the base of the diffuser.
2.
Place the diffuser on a flat and stable surface and away from the edge.
3.
Remove the diffuser's outer and inner cover.
4.
Pour mineral water (bottled or tap water) into the water tank up to the maximum level indicated (120 ml).
5.
Add a few drops of essential oils (3-12 drops) to the water tank.
6.
Replace the inner cover and the outer cover on the diffuser.
7.
Plug the adaptor into the appropriate outlet.
h
s d
f
u
e
a
u
c
i
T
i
i
f
s
r h
3 s f
n
t
o
ON/OFF (middle button) :
1.
Press the ON/OFF button once to turn on the device and start the continuous diffusion (highest mist vol u me
diffusion: 30 ml/h)
2.
Press a second time to operate the diffuser for 60 minutes. After these 60 minutes, it will stop automatically.
3.
Press a third time to start the cyclic diffusion. The device will operate for 30 seconds and stop for 30 seconds
during 120 minutes. After that, the device will automatically stop.
4.
Press a fourth time on the ON/OFF button to switch completely the diffuser OFF.
Mist volume (Left button) :
1.
Press once to get the middle mist volume diffusion (22 ml/h).
2.
Press a second time to get the lowest mist volume diffusion (15ml/h).
3.
Press a third time to get the highest mist volume diffusion (30 ml/h).
Warm Light (Right button):
1.
Press once to switch on the color changing mode
2.
Press a second time to sets to one color (to the color currently shown)
3.
Press a third time to switch off
Remark:
When the water level in the tank is too low or at zero, the diffuser stops automatically. To go back to a normal working, top the
water up by following the « Precautions for use » steps.
PRECAUTIONS FOR USE
n b
t
o
s o
h
r
n
u
t
n
n t
e f
o
t s
WORKING
i
e
d
:
Werbung
Inhaltsverzeichnis
