Veria S-3001W-301 Bedienungsanleitung Seite 44

Notice
It is better to turn off the data flow when connecting to the network, use Wi-Fi communication, and firstly use Wi-Fi
to test whether the network is smooth, the signal is better to be above 90%, because the EZ mode uses the
roadcast mode, and The strong signal will make the connection more easy to succeed.
If the connection using EZ mode is unsuccessful, generally there are the following points：
1: The encoding and decoding methods of some older Wi-Fi routers are relatively old and do not support EZ Quick
connection In this case, you can only connect using AP mode.
2: If you connect a high-definition Wi-Fi camera to a Wi-Fi router,it will also affect the success rate of the
connection, because high-definition video will take up a lot of bandwidth and cause broadcast interruption during
the EZ mode connection,successful configuration will be more difficult. The method can be to first suspend the
power supply of the Wi-Fi camera, and then resume the power supply of the camera after the connection is
successful; or use the AP mode to connect.
3: Do not connect more than two devices at the same time under the same router environment, otherwise they will
cross code with each other. You can turn off one of them then connect the other one.
AP MODE
To quickly configure the interface and configure the AP mode in (Settings>Network Interface).
Note:If the network settings are not loaded, press the highlighted button and restart.
Net pairing Mode
Cloud services
WIFI hotspot
Password
UUID
Quick setup
After reboot, the data for the WIFI hotspot is loaded.
Net pairing Mode
Cloud services
WIFI hotspot
Password
UUID
Quick setup
Continue with the TUYA application for further settings.
Network setting
AP Mode
Unconnected
*CVBFX02***
Network setting
AP Mode
Unconnected
SmartLife-xxxxxxxx
12345678
*CVBFX02***
43
EN
6#