Veria S-3001W-301 Bedienungsanleitung Seite 41

Ⓒ
Picture
Doort station installation
Installation A :
Surface mounted using a mounting frame
directly to the substrate using the mounting
material provided
The installation of the entrance camera unit is surface mounted, so we recommend applying a layer of silicone
between the entrance unit and the wall. This layer should be applied on three sides (top and sides), the bottom
side must remain free for moist air to escape.
Always secure the camera input unit with a locking screw.
Ⓓ
Picture
Monitor installation
Install the monitor according to the instructions. Use the supplied adapter for power supply or a power supply
with the same parameters. Do not place the monitor near heat sources.
The monitor is full touch, please use a damp cloth for maintenance.
Ⓔ
Picture
Add/Remove RFID
To add/remove RFID keychains, follow the pictorial manual. The package includes 5 RFID keychains. Use the
chips at a frequency of 13.56 MHz. The maximum number of chips added is 200 per unit.
An authorized RFID keychain will emit a long beep-beep tone when attached.
WIRNING CONNECTION
The connection between the monitor and the door station is 4-core.
The effective distance from the outdoor camera to the furthest indoor monitor:
Transmission <30m (4x0.4mm)
Transmission <60m (4x0.65mm)
If you want to extend the distance to more than 60m, it is best to choose thick copper core cable, shielded wire
or 3-core ordinary unshielded wire + video cable. Connect the shield terminal to GND.
For longer distances, we recommend using the SYKFY cable.
If user wants to use CAT5 or CAT6 network cable.effective distance from the outdoor camera to the furthest indoor
monitor will be limited. For unshielded network cable, the distance will be up to 20m. For shielded network cable,
the distance will be up to 40m. CAT5 or CAT6 network cable consists of 4 pairs of twisted pairs(8 wires), here one
pair of twisted pair will be used as one cable. Green White+Green, Brown&White+Brown, Orange&White+Orange,
Blue&White+Blue.
If it is a shielded wire, it must be connected to GND.
DC12V
AUDIO
GND
VIDEO
SHIELD
Installation B:
Surface mounting using an angle bracket
40
DC12V
AUDIO
GND
VIDEO
SHIELD
EN