Garden Groom Midi Bedienungsanleitung Seite 6

•
The specified vibration emission value limits the working hours. If you notice a tingling or
discolouration (white) of the fingers then stop working with the tool.
•
Warning: The actual value of existing vibration emissions while using the machine may differ
from those in the manual respectively by the manufacturer. This can be caused by the following
factors to be considered before or during any of use:
- Is the machine used correctly?
- Is the method of cutting the material and how it is processed correctly?
- Is the state of use of the machine in the regulatory?
- Sharpness condition of cutting tool and proper cutting tool?
- Are the grips firmly mounted on the machine body?
•
If you observe an uncomfortable feeling or a discolouration of the skin from your hands
while using the machine, please immediately stop working. Take adequate breaks from work.
In disregard of adequate work breaks, there may be a hand-arm vibration syndrome.
•
There should be occur an appraisal of an utilization factor subjected to the work respectively of
usage the machine and place appropriate work breaks. In this way, the utilization factor during the
entire working time can be significantly reduced. Minimize your risk, you are exposed to vibration.
Maintain the machine following the instructions in the manual.
•
Avoid the use of the machine at a temperature of T = 10 ° C or less. Make a work plan so that
the vibration load can be limited.
•
A degree of noise from this machine is not avoidable. Postpone noisy operation at licensed
and certain time periods. As the case may be observe rest time periods and restrict the working
hours to a minimum. For your personal protection and protection of people working nearby, an
appropriate hearing protection is worn.
Use and handling of the electrical tool
•
Do not overload the device. Use the electrical tool intended for your work.
•
Do not use the electrical tool if its switch is defective.
•
Remove the plug from the mains socket and/or remove the storage battery before making
adjustments to the appliance, changing accessory parts, or putting the appliance away.
•
Keep unused electrical tools out of reach of children. Do not let people use the appliance who
are not familiar with it or who have not read its instructions.
•
Keep cutting tools sharp and clean.
•
Before use, make sure the cutting head is firmly attached.
•
Handle electrical tools with care. Make sure moving parts function perfectly and do not jam and
check whether parts are broken or damaged in such a way that the function of the electrical tool is
impaired. Have damaged parts repaired before using the appliance.
•
Always check the appliance for damage before putting it into operation. If the appliance, cable,
or plug show visible damage, they may not be used. Do not use the appliance if it shows signs of
a malfunction.
•
If the appliance has a fault, do not attempt to repair it yourself. In the event of damage please
contact Customer Service (see section entitled "Customer Service").
•
Only have the device repaired by a qualified professional.
•
Only use original accessories and original spare parts.
•
Do not make any changes in the appliance.
•
Use the appliance only when it is properly assembled and operational.
•
Use the electrical tool, accessories, insert tools, and so on according to these instructions. In
the process, take the working conditions and task to be performed into consideration.
•
Before use, familiarise yourself with the environment and pay attention to any sources of
.6.