Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before operation
ATTENTION! Do not place the unit directly beneath a wall outlet. In the case of non-
observance danger of injury and / or damage to the unit can result.
ATTENTION! Please pay attention that you do not pinch the power line and protect
it against sharp edges. Damaged power lines increase the risk of an electric shock.
Note: Make sure that the electric wall heater is correctly installed. In case of any
Instructions: Please keep in mind that the power cord must also remain
is suitable for mounting the product with the supplied screws/plugs (the product is
supported by 2 screws only . The bottom screw is meant for securing the product.).
When looking for a suitable location for installing the electric wall heater
safety instructions into account. The product has to be mounted level.
At least 60cm of free space is required at the top of the product and at least 20cm
•Drill the holes (07mm) in the wall according to picture C.
•
•Mount the heater to the wall by means of the two upper screws.
•Mount the safety bracket on the back side of the product.
•Tighten the bottom screw .
•Put the decoration stones on the brim on the front side of the product.
•Mount the glass by using the four pins at the sides of the product.
•Insert the power plug 3 into an earthed outlet.
Note: Please observe that the power plug must still be able to be reached after
Operation
plate of the heater . Devices marked with 230 V can also be operated with 220 V .
Before operation it is imperative to make sure that the installation location
corresponds to the requirements of the safety instructions.
Note:
develop. This odour develops due to the heating up of the inner heating elements.
detected the room temperature decreased over 3 comparing to the temperature set
within 0.5 hour
show "00".
7
Werbung
Inhaltsverzeichnis
