Install An Sd Card (Optional) - Axis Communications T99A10 Installationsanleitung

AXIS T99A10 Positioning Unit 24 V AC/DC
Important
These instructions apply only to device firmware earlier than v8.40.
1. Go to the product's web page.
2. Go to Setup > PTZ > Advanced > Device > Extended Driver Specific Settings for
Video Source 1.
3. For Illuminator > IL1 type:
— Select IR if you connected an infrared illuminator
— Select White for a white light illuminator
4. Repeat the above step for lluminator > IL2 type.
Important
These instructions apply only to device firmware v8.40 or later.
1. Go to the product's web page.
2. Go to Settings > System > Accessories.
3. For Illuminator > IL1 type:
— Select IR if you connected an infrared illuminator
— Select White for a white light illuminator
4. Repeat the above step for lluminator > IL2 type.

Install an SD card (optional)

A standard or high capacity SD card (not included) can be used to store recordings locally in the
product. See Specifications on page 43 before installing the SD card.
1. Disconnect power from the product.
2. Remove the four top cover screws and remove the top cover.
3. Insert an SD card into the SD card slot, see Hardware overview on page 16 .
4. Replace the top cover and tighten the screws (torque 3.0 Nm).
5. Re-connect power to the product.
41
EN