Install The Ptz Driver; Install The Illuminator Kit (Default Installation) - Axis Communications T99A10 Installationsanleitung

AXIS T99A10 Positioning Unit 24 V AC/DC
3. Replace the lid and tighten the four lid screws (torque 3.0 Nm).
4. Apply power to the product.

Install the PTZ driver

This product supports several devices. For a complete list of supported devices, see axis.com
Important
Some cameras may need to be installed upside down in the camera housing and some may
use the auto-rotation feature. Before you install the PTZ driver, edit the image settings on
your camera's live view to rotate the image, and turn off autorotation.
1. Go to the camera's webpage.
2. In the installation wizard, go to Select a PTZ mode and select PTZ driver from the
drop-down list.
3. Once you've accessed the live view, go to Settings > System > Accessories.
4. Select one of the following actions:
4.1 If the PTZ driver is not uploaded, select Upload driver.
4.2 If the PTZ driver is uploaded, go to Select driver to use and select PTZ driver
from the drop-down list.
5. Select a video channel.
6. Enter the Device id and select Device type from the drop down-list. To decide which
device type to use, see the documentation supplied with the PTZ driver.
7. Go to the PTZ tab and check that the PTZ settings are available.

Install the illuminator kit (default installation)

WARNING
• Risk of electric shock. Make sure the power supply is disconnected.
• Emission of infrared light (risk group 2) from the illuminators can be harmful for eyes.
Pay attention to the provided indications. To reduce the risk of eye damage, avoid eye
exposure, and use appropriate shielding or eye protection at distances of less than
1.5 m (4.9 ft).
CAUTION
During normal operation, the surface of the illuminator can reach high temperatures. Do
not allow direct contact and position the appliance where it is inaccessible to unauthorized
personnel. Before touching, switch off the illuminator and allow to cool for a minimum
period of 10 minutes.
35
EN