Technical Data - Meec Tools 019859 Bedienungsanleitung

EN

TECHNICAL DATA

Rated voltage
Output
Output voltage
Cord length
Weight
DESCRIPTION
Induction gun heater with LED in front. Grip-
friendly with ergonomic handle. Supplied with
soft and malleable induction loop and three
induction coils 18, 22 and 28 mm.
1. Induction coil
2. Connection for induction coil
3. LED light
4. Ventilation opening
5. Power switch
6. Wing screw
7. Ventilation opening
8. Power cord and plug
9. Induction coil, 1 m malleable
10. Induction coil 28 mm
11. Induction coil 22 mm
12. Induction coil 18 mm
FIG. 1
USE
PREPARATIONS
WARNING!
Check that the mains voltage corresponds
to the rated voltage on the type plate. If the
voltage does not correspond with the data
on the type plate there is a risk of serious
personal injury and/or material damage.
• Check before use that the induction coil is
firmly in place.
• The product can be used continuously for
no more than 5 minutes, after which it
14
230 V ~ 50 Hz
500 – 900 W
40 V
3 m
3 kg
should be switched off for at least
5 minutes before using it again.
The product has overheating protection,
but accessories are not protected and
must not be used continuously for more
than 5 minutes.
• Check that the cooling fan starts when the
power switch is pressed. Do not use the
product if the cooling fan is not working
properly.
• The soft induction coil must not be turned
more than four times. 2 or 3 or 4 turns
are optimal for best functionality.
• Do not leave the induction coil connected
to the product when the product is not in
use.
• Do not dismantle the product or attempt
to repair it. Contact the retailer if you have
any problems or questions.
HOW TO USE
IMPORTANT:
Do not connect the product to a portable
generator. An irregular voltage can damage
the product and will invalidate the warranty.
1. Chose the induction coil that fits best
to the workpiece, but leave a gap of 10
mm between the induction coil and the
workpiece. The insulation on the heating
coil burns in time on contact with hot
objects.
2. Put the ends of the induction coil in the
connections and tighten the wing screws.
3. Start the product with the power switch
and wait 1 to 3 minutes for the workpiece
to warm up enough to stop corrosion.
4. Switch off the product by releasing the
power switch and allow it cool for at least
20 minutes. Avoid handling the product or
accessories before they have cooled – risk
of burn injury.
5. When the product has cooled, check that
it is switched off and pull out the plug.